![]() ![]() Drive the vehicle for at least 5 minutes to confirm Zero Point Calibration is complete.įYI, what about vehicle that doesn’t have the VSC light?įor example, if you have a Toyota noah year 2005 with 1AZ-fe engine that have trouble code P1589 acceleration sensor learning value. Remove the SST from terminals Ts and CG of DLC3.ġ5. After ensuring the blinking of the VSC warning light for 2 seconds, turn the ignitionġ4. After turning the ignition switch ON, check that the VSC warning light is lit for aboutĤ seconds and then starts quick blinking at 0.13 second intervals.ġ3. Connect terminals Ts and CG of DLC3 using the SST.ġ2. After ensuring that the VSC warning light remains OFF for 2 seconds, turn the ignitionġ0. ![]() ![]() Check that the VSC warning light goes off about 15 seconds after the ignition switchĩ. Be sure the terminals Ts and CG of DLC3 are disconnected.Ĩ. Verify that the VSC indicator light is lit indicating the recorded zero point is erased.Ħ. Using the SST, repeat a cycle of short and open between terminals Ts and CG ofĭLC3 4 times or more within 8 seconds (refer to the specific vehicle EWD for TS andĤ. If the vehicle is equipped with a M/T, ensure that theģ. If the vehicle is equipped with A/T, ensure that the shift lever is in the “P” range and The vehicle must remain in a stationary condition throughout the entire process.īe sure to perform the procedure on a level surface with an inclination of less than 1%.ġ. While performing the Zero Point Calibration, do NOT tilt, move, or shake the vehicle. The following manual procedure may be used in the cases where a Diagnostic Tester is Optional method one: Zero Point Calibration Using Jumper wire This post provides two optional methods to do Toyota Zero Point calibration, one is to use Jumper wire, and another one is to do using Toyota TIS techstream cable. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |